Pro Blind 2™

Watch the setup video

In this short 2 minute video, you’ll learn the essentials needed to utilize your Pro Blind 2™.


Key steps for setting up your fixture...

Step 1

Unbox your fixture and its parts. Included are the fixture, power cord and short DMX cable.

Step 2

Attach the power cable by inserting the blue PowerCon™ connector into the fixture and twisting it to lock.

Step 3

Plug into power.

Step 4

Patch the fixture into your software or controller. (View patching example below)

Step 5

Set the DMX address and Mode using the menu + up/down buttons.

Step 6

Mount your fixture and connect DMX cable to your other fixtures, distributor or controller using the in/out DMX port.

Fixture Profiles


Software patching examples

Don't see your controller listed?
Simply follow the concepts outlined in the patching examples.
View your specific software or controller manual for related patching instructions.


Pro Blind 2™ User Manual


If you’d like to control blinder LED pot individually, set the Pro Blind 2™ to Basic DMX mode (

Your software will dictate what DMX address you should set to your fixture. View the software patching examples on this page for more detail.

Rigging guides are available to PCL customers only. Please login to view detailed rigging guides.

Check to make sure the PowerCon™ end is twisted and locked into the fixture. Check the fuse. Check the power cord and power source.

This is most likely caused by your DMX or Mode being set incorrectly. Please check your DMX addressing and mode settings.

Yes, simply use a power chain cable to connect power between fixtures. Up to 6 fixtures can be chained together.

PCL customers, please login to view software tutorials, training videos and courses.