Zoom Mini™

Watch the setup video

In this short 2 minute video, you’ll learn the essentials needed to utilize your Zoom Mini™.


Key steps for setting up your fixture...

Step 1

Unbox your fixture and its parts. Included are the fixture, power cord, short DMX cable and 1 quick-connect bracket.

Step 2

Attach the power cable by inserting the IEC plug connector into the fixture.

Step 3

Plug into power.

Step 4

Patch the fixture into your software or controller. (View patching example below)

Step 5

Set the DMX address using the menu + up/down buttons.

Step 6

Mount your fixture and connect DMX cable to your other fixtures, distributor or controller using the in/out DMX port.

Fixture Profiles


Software patching examples

Don't see your controller listed?
Simply follow the concepts outlined in the patching examples.
View your specific software or controller manual for related patching instructions.


Zoom Mini™ User Manual


If you’re hanging your fixture, you’ll need to utilize the quick connect bracket. Attach the bracket to the bottom of the fixture and utilize the included screws to fasten it.

Rigging guides are available to PCL customers only. Please login to view detailed rigging guides.

Your software will dictate what DMX address you should set to your fixture. View the software patching examples on this page for more detail.

Check to make sure the IEC plug end is seated firmly into the fixture. Check the fuse. Check the power cord and power source.

This is most likely caused by your DMX or Mode being set incorrectly. Please check your DMX addressing and mode settings.

No, the Zoom Mini™ does not have power chain ports.

PCL customers, please login to view software tutorials, training videos and courses.